pull down to refresh

0 sats \ 2 replies \ @ContraMundum 5 Aug \ on: Tell Me How To Make This DIY
Bottle Holder Design
Specifications:
•	Material: 1000D Cordura
•	Length: 14.5 cm
•	Base Dimensions: 6.5 cm x 6.5 cm
Components:
1.	Main Body: Rectangular piece that wraps around the bottle.
2.	Base: Square piece that forms the bottom of the holder.
3.	Seams and Hemming: Edges to be sewn together.
Blueprint Outline
Main Body Piece:
•	Dimensions: 14.5 cm (height) x 26.0 cm (width)
•	This width includes 2 cm extra for seam allowance (1 cm on each side) and overlap for stitching.
Base Piece:
•	Dimensions: 6.5 cm x 6.5 cm square
•	Add 1 cm seam allowance around the perimeter, making it 8.5 cm x 8.5 cm total.
Steps to Assemble:
1.	Cut the Cordura Fabric:
•	Cut one rectangle of 14.5 cm x 26.0 cm for the main body.
•	Cut one square of 8.5 cm x 8.5 cm for the base.
2.	Prepare the Edges:
•	Hem the top edge of the main body piece by folding over 1 cm of fabric and stitching it down.
3.	Assemble the Base:
•	Pin the base piece to the bottom edge of the main body rectangle, right sides together.
•	Sew along the edges, leaving a 1 cm seam allowance.
4.	Form the Cylinder:
•	Bring the two short sides of the main body rectangle together, right sides facing, and sew them to form a cylinder.
5.	Finish the Seams:
•	Reinforce the seams with additional stitching if needed.
Here is a simple diagram for visualizing the pieces:
Main Body Piece:
| | | | | | | | | | | | |_________________________| |<---- 26.0 cm ---------->|
Base Piece:
| | | | | | | | |________| |<--8.5 cm-->|
write
preview
0 sats \ 1 reply \ @Fabs OP 5 Aug
What's this? I can tell from the provided measurements that this ain't gonna work out...
reply
0 sats \ 0 replies \ @ContraMundum 5 Aug
I tried. Sorry.
reply